Safety Disclaimer

Last updated: November 19, 2026

FirstLayer.blog publishes general information about 3D printers, materials, software, upgrades and troubleshooting. It is provided for informational and educational purposes only.

Hot parts, moving parts and electricity

Nozzles, hotends and heated beds reach temperatures that cause burns, and printers move under their own power. Let parts cool and switch the printer off before working on it. Many printers run on mains power or a power supply connected to it. Only open a power supply or change wiring if you are qualified to do so, and unplug the printer first.

Fire risk

Faulty wiring, loose connections, failed thermistors and disabled safety features can cause fires. Keep thermal runaway protection enabled, do not leave a printer running unattended for long periods unless you have taken precautions such as a smoke detector nearby, and keep flammable materials away from it.

Fumes and particles

Printing plastics, especially ABS and ASA, releases fumes and ultrafine particles. Print in a well-ventilated area, or use an enclosure with filtration or venting, and follow the material manufacturer’s guidance.

Resin and solvents

Liquid photopolymer resin can irritate skin and eyes and cause allergic reactions. Wear nitrile gloves and eye protection, work with ventilation, and follow the safety data sheet for your resin. Isopropyl alcohol used for cleaning is flammable. Dispose of uncured resin and contaminated liquids as local rules require, not down the drain.

Printed parts

3D-printed parts can be weaker than they look and can fail without warning. Do not rely on them for safety-critical uses, such as load-bearing parts, vehicle parts, or anything whose failure could injure someone. “Food-safe” filament does not make a printed part food-safe, because layer lines and the printer itself can hold bacteria or contaminants.

Modifications and warranty

Changing firmware, hardware or settings can void your warranty and damage your printer. Follow the manufacturer’s instructions and make changes at your own risk.

Products and links

We compare printers, materials and software based on published specifications, documentation and public information. Some links may be affiliate links, which means we may earn a commission at no extra cost to you. This does not change what we write. Product details and prices change, so check them with the seller before you buy.

Your responsibility

You use the information on this site at your own risk. To the fullest extent permitted by law, FirstLayer.blog is not responsible for any injury, damage or loss that results from using it. See also our Terms of Use.

Questions: info@firstlayer.blog